characteristic: has a complete set of imported motor, circuit. The gluing evenly, high precision, no leak adhesive. 90 w + 1: 10 gearbox, powerfully. Indexable head, easy to use.

Specification:

1.5 "/4" / 6 "9" / 12 "(inches) is regular gluing dimension, different dimension has different price, we can adjust according to customer order.

2: suitable for rubber belt use, can free adjustment to the required width is sealed and turn for a long time, does not volatilize, never frozen, don't have to clean the machine always like new.Fully automatic no period of variable speed control, speed can be adjusted freely.General super glue, gasoline adhesive can be used with rotary device, when they stop using recycled plastic fluid never leak adhesive, the gluing quantity can be adjusted freely.

This machine use for footwear, leather products (luggage, wallet, briefcase), stationery industry clips, folders, paper clip (notes), belt whole plant equipment, and opposite, picture frames, sport equipment use.

Three instructions:

1. Confirm the plug in the power supply of 220V or 110V

2. Turn on the left side of the motor control, see whether shaft to rotate, confirm whether there is dry glue inside the wheel.

3..Speed adjustment knob to zero, can open the power switch,

4. Turn on switch, motor speed adjustment, slowly adjusting knob (not too tight), thickness of shutdown speed when the knob must return to zero and then shut off the power switch, to ensure the safe operation of the electrical appliances.

5. Rotate the bottle up and lock fastening missile d etection pouring glue. 6. The thickness of workpiece, adjust the following two flowers round (same direction rotation) observation height, bottom round with the eye line the workpiece optimum gluing A check, how much glue water again in accordance with the need to adjust the amount (right) round knob, after set, can work normally, should pay attention to in using current meter's instructions, such as current over 1.5 A above shows that there is something wrong with the overload lugs, need to deal with prompt processing work (on)

Four tips from work:

1. While going off work, please put the bottle to fall down, make glue back inside the bottle, let the motor run at low speed.

2. Will the glue on the roller with glue knob put its first clean and days that water and a little brush rotation while cleaning, clean after will be transferred to speed control knob.

3. Close the motor reoccupy hand rotation handle rotation while cleaning, make the lugs on the absolute no glue, feel is relaxed

4. Next time when you use the boot, rotary motor controller to see if easily by hand, and if is very tight, please add water, that day on the tire after a few minutes, and then the rotary motor controller to see if feasible easily by hand,

5. If the more relaxed just can open the power supply work and instead have to add water, that day let the dilution time longer, trial run again.